Creating a Ext2 partition and setting the '/boot/' mount pointĭ. Deleting the partitions from the old Kali install and leaving free spaceī. I said it before and I'll say it again, backup your drive before you get started.Ī. debs and dependencies required and place them within the thumb drive at /pool/main/ but it's easier to connect to the net. While the 1.08 USB is EFI enabled, it does not include the. You need to be connected to the internet for this install. Throughout, I will be working with a value of 95GB of free space. ![]() From what I have seen, this is the same scenario generated by the Kali installer automatically if the entire disk is encrypted. Please post if you have insight into this setup. I am not an expect on the (if any) security implications of this setup. boot will be on a separate unencrypted partition.Īs mentioned above, /boot is mounted on a separate partition and is not encrypted. This means our '/' and 'swap' are encrypted at boot time. My setup is provided below so others know it should work for them if they are similar, please post your experiences.ĮFI boot Kali 1.08 on an encrypted volume which contains a Logical Volume Group with '/' and 'swap' as separate Logical Volumes within it. The end result we are working towards is a dual boot Windows (I'm on 8.1) and Kali 1.08 where Kali is installed on an encrypted LVM.īackup your drive before proceeding, it's easy to nuke anything while messing with partitions ![]() As I dual boot with Windows I needed another way. Catch was, this only supported the install if I used the entire disk. ![]() ![]() I decided I would reinstall Kali 1.08 and go for an encrypted install as I'm sure some of us have considered.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |